Devices using only the basic bits of wire, one in two ways, in order to secure small appliances on the go, you know the solar charger Solar battery charger, instead of belonging to a glamorous gadgets, lively features and gadgets that you are responsible for what they maintain is a lot of people especially on this day, and use a lot of portable electronic devices We

It is here that we will need a list:

- A beautiful, old window

Per cell - a multimeter (about 0.5 volts)

- 12 cells

- Soldering

- AA battery holder

- Adhesive tape

There are procedures for solar power to recharge the battery of these ways:

1Layout, and all cells on the window to fit everything in Use the deep side windows to allow more room for backups

Two1 3 We have six cells that require an array of bolts As the process easy to break them really paying attention 3 to obtain a single cell, wire back to a few times before Because the two cell lines from the bottom of the front of the back to one of the following two parts, you must have two soldered to the second

ThreeSolder before returning to the three lines into a single cell, where contact with iron, it is touching the soldering iron, take a pull off These are the cells that line of wire-line responsibility to ensure that the panel format allowed to flow into electronic load, please be soldered

Four2 and the second set of solder from the front, the first of these three connected to one of your two three, this time there is a need to move to the back

FiveThis window was not able to hold them all in a long line, no longer have to be laid out in the shadow pattern of the cell stack will be difficult to get something shining in the sun

SixThe other six to obtain the cells and solder them using the same procedure The three when the two must have completed an array of bolts Case) is positive (the front two and three require an array of negative bolts (back) wire them coming

7In parallel, with just those two wires twisted two wires together with a positive one negative line Now two lines with a single positive line of positive-negative lines of the two will become one of the two lines negative

8Three single-radio shack battery holder to the red lead is negative lead line connecting the black wire to battery holder positive

NineAffix is going to lead to negative battery, blocking diode The background is shaded from the flow when the battery cells help to maintain the current

TenSome parts from the cardboard box back into each cell of the duct tape Put it under the sun

Therefore, solar power is to charge this way And, please remember these tips:

- If the charger the clock, the sun is too bright for too many, you can charge enough to ruin the battery

- Make sure the batteries in the multimeter to keep them from charging hourly